These rugged, 3/4 inch diameter sensors are constructed entirely of stainless steel and are available in ranges of 0.100 inch (2.5 mm) to 20.00 inches (500 mm). The coil windings are sealed against hostile environments to IEC standard IP-68 and electrical termination is through either a sealed axial connector (HSE/HSI) or a sealed radial connector (HSER/HSIR). The radial connector offers two important benefits. First, it results in a through-bore design, which permits access to either or both ends of the LVDT’s core for better mechanical support and core guidance, and easier cleanout in dusty or dirty locations. The second advantage of the radial connector is shorter installed length compared to units of the same range with axial connectors. Units are supplied with built-in electronics for either DC operation with a pre-calibrated 0-10VDC output (HSE) or 4-20 mA current loop operation (HSI). The standard maximum linearity error for a HS 750 Series sensor is ±0.25% of full range output, with ±0.10% available as an option.
Ranges of 0.100 inch to 20.00 inches
Non-linearity less than ±0.25% (±0.10% optional)
Repeatability of 0.000050 inch
0-10VDC or 4-20mA outputs
Rugged, stainless steel construction
Coil environmentally sealed to IEC IP-68
Axial or radial connectors w/ mating plug included
Please carefully read the disclaimer before using any of this data. Your use of this data constitutes your acceptance of the terms and conditions set forth below. If you do not agree to those terms and conditions, please click on the I Disagree link.
This information has been provided to your free of charge for your use but remains the sole property of TE Connectivity Corporation (''TE'') or SnapEDA, Inc. or Ultra Librarian/EMA Design Automation, Inc. (collectively, "Company"). While Company has used reasonable efforts to ensure its accuracy, Company does not guarantee that it is error-free, not makes any other representation, warranty, or guarantee that the information is completely accurate or up-to-date. In many cases, the CAD data has been simplified to remove proprietary detail while maintaining critical interface geometric detail for use by customers. Company expressly disclaims all implied warranties regarding this information, including but not limited to any implied warranties or merchantability or fitness for a particular purpose.