Build and price the product now


These rugged hermetically sealed sensors are constructed entirely of stainless steel and intended for general industrial use.  The coil windings are sealed against hostile environments to IEC standard IP-68. The GHSA 750 electrical termination is through a sealed axial connector. The GHSAR 750 electrical termination is through a radially mounted sealed connector, which results in a much reduced installed length. The mating connector plug is supplied with the unit. The sensor consists of a spring loaded shaft running in a precision sleeve bearing and connected to the core of an LVDT. The use of a precision sleeve bearing results in measurement repeatability of 0.01% of full range or better. The output from the LVDT can be connected to any standard LVDT signal conditioner and then passed to a gaging column display, digital readout, or computer based data acquisition system. The probe shaft is fully extended by a spring exerting a nominal force of 6 to 20 ounces depending upon total range. The contact tip supplied is an AGD standard number 9 made from chrome plated hardened tool steel. It is fully interchangeable with other AGD contact tips. 


  • Ranges of ±0.050 inch to ±2.00 inches
  • Repeatability of 0.01% of FRO
  • Non-linearity less than ±0.25% of FRO
  • Coil environmentally sealed to IEC IP-68


Please review product documents or contact us for the latest agency approval information.  

Electrical Characteristics

  • Supply Voltage (V) 3

  • Electrical Connections  PT02A-10-6P

Signal Characteristics

  • Excitation Frequency (kHz) 2.5

Body Features

  • Spring Loaded  Spring Loaded

Housing Features

  • Housing Material  Stainless Steel

  • Housing Diameter  19.05 mm [ .75 in ]

Usage Conditions

  • Operating Temperature  -55 – 105 °C [ -67 – 221 °F ]

Industry Standards

  • IP Rating  68


  • Full Stroke Ranges (mm) ±1.27, ±12.7, ±25.4, ±3.17, ±50.8, ±6.35

  • Full Stroke Ranges (in) ±.05, ±.125, ±.25, ±.5, ±1, ±2

  • Linearity (% of Span) ±.25

Related Materials

Terms and Conditions

Please carefully read the disclaimer before using any of this data. Your use of this data constitutes your acceptance of the terms and conditions set forth below. If you do not agree to those terms and conditions, please click on the I Disagree link.


This information has been provided to your free of charge for your use but remains the sole property of TE Connectivity Corporation (''TE'') or SnapEDA,  Inc. or Ultra Librarian/EMA Design Automation, Inc. (collectively, "Company"). While Company has used reasonable efforts to ensure its accuracy, Company does not guarantee that it is error-free, not makes any other representation, warranty, or guarantee that the information is completely accurate or up-to-date. In many cases, the CAD data has been simplified to remove proprietary detail while maintaining critical interface geometric detail for use by customers. Company expressly disclaims all implied warranties regarding this information, including but not limited to any implied warranties or merchantability or fitness for a particular purpose.